Aceros URSSA, offers quality not only in steel, but also in assistance about the selection of a material, with a wide stock that can offer immediate availability, Oxycut and a quick availability.
We help you to choose the most convenient steel for your needs: resistance to impact, traction, thickness, surface finishings, applications, etc.
Use our warehouse as if it were yours. We do have a wide stock in steel plates with a thickness ranging from 1.5mm to 400mm and different types (tempered, stress-relieved, resistant to wear and tear, anti rust and special qualities). All of them aim to be immediately served.
In order to offer the most extensive service, you can collect your steel cut with millimetric accuracy, with the aid of our Oxycut department
With the aid of our two warehouses, we are ready to answer your order from anywhere in the world.
We export our products outside Spain, mainly for France, Portugal and Morocco.
Steels with good weldability, toughness and anti-wear for applications which require maximum resistance to wear and tear.
Steels with good weldability, toughness, and anti-wear for applications where maximum resistance to wear is required.
URSSA has the oxyfuel technology capable of cutting steel sheets with millimetric accuracy up to 400 mm thick (greater thicknesses on request).
For this we have splitting lines as ESAB, OXYSER and MAINOX capables to proceed sheets until 12.000x3.000 mm, run by numerical control by LANTEK sotware.
Based on its plans, Urssa makes conversion to CAD and ensures a cut steel to your requirements, even in artistic works as monuments.
We give the maximum importance to the quality finishing:
For material which need warm treatment after the cut, we have annealing furnaces and stabilization of pieces of 3.000x2.200x900mm.
The oxycut is a cutting metal sheets by thermal jet process, in which, to make an accurate material cutting, results a metal combustion. The reaction results through Fe (fuel), O2 (combustible) and torch flaming.
When you cut, the metal is burned, remaining critical the presence of alloy components which reduce combustion steel capacity. Because of that this is a very suitable technique for moderate in carbon and alloying content.
The oxycut process allows you to do high quality cuts: with the cut surfaces perpendicular with soft waters, without bites, with the angular edge (not cast and not rounded) and with the bottom edge free of slags and burrs. It also allows you to do any type of rectilinear and curve cuts on sheets over 500mm thickness.
By sending us your maps, steel quality and needs to firstname.lastname@example.org we quote your offer In a few hours.
To start up your order we will ask you for your plans and dimensions of the final mechanized pieces to calculate the necessary oxycut amounts.
We cut pieces in thickness until 500mm and greater*.
We have annealing furnaces and stabilization of pieces of 3.000x2.200x900mm.
* Due to the heating effect in the oxycut process, we do not recommend to cut pieces in thickness less to 6 or 8 mm, according to dimension.
CORTEN steel is a high weatherability steel thanks to a surface oxide layer that protects it from external agents.
Steels of different properties used for various types of constructions and applications. Carbon steels, or also known as construction steels, form more than 90% of all steels currently marketed. These steels can contain varying amounts of carbon. The concept of construction steel encompasses both steel for civil construction and steel for mechanical construction.
Steels for pressure vessels, boilers and low temperatures.
Steels specially designed for ballistic protection in civil or military applications. Its composition provides high protection with significantly less weight.
Also, we serve other special steels that we can serve under demand.
Had any other special needs in special steels?
Please contact us
We cut your steel plates starting from your plans with absolute accuracy. An added service which allows collecting the product ready to be used.
Wide stock in steel plates with a thickness ranging from 1.5mm to 400mm and different types. Ask us for more information.
Wide range of thicknesses, from 1mm to 80mm thickness. Oxcut custom made from 8mm to more than 500mm thick